Angelcare AC420 Owner's Manual download pdf (Page 6)

ICON MEANING FUNCTION AND USE

NURSERY UNIT

Power switch on the left wing. Power ON = -

Power OFF = o

Night light button and channel

selector

1) Press ON/OFF for night light.

2) Push to change channel when the parents unit is on Channel Selection

Mode. (See the Channel Key section.).

In range selector on the right

wing

Increases and decreases the voice activation sensitivity.

Your Angelcare® monitor is equipped with a voice-activated system. The

nursery unit will be activated and transmit sounds to the parents unit only when

it captures sounds. The sensitivity dial allows controlling the level of sound

picked up and transmitted by the nursery unit.

Note: If the microphone sensitivity level on the nursery unit is set to maximum

(completely to the right), the unit will revert to continuous sound reception

instead of voice activated mode.

Microphone sensitivity dial

(Back of the Unit)

Slide switch Up to be notified when the nursery unit signal does not

reach the parents unit. (See the “In Range” icon section.).

Power ON (green light)

and Low-battery indicator

(Flashing green light)

1) When the power is ON and the left wing button at the “-” position, the

green light will appear.

2) If the back-up batteries are low, the green light will flash.

Note :The green light will flash for 45 minutes before unit shuts itself OFF.

Testing Your Angelcare

Monitor

Note: Test your Angelcare

Monitor BEFORE first-time use

and then periodically.

Step 1. Have someone else speak into the nursery unit or place

a radio near nursery unit. You should hear sound from the parents

unit. If there is no sound, refer to the Troubleshooting section.

If reception is not clear, switch to another channel (see

channel key in the Icon section).

Step 2.

Verify that the battery mode is functional by operating the

nursery unit without the AC adaptors. The green Power light should

appear on the Nursery unit and the digital screen should light up on

the parents unit.

Parents unit: When the Low Battery indicator icon is almost

clear, place the unit on the charger.

Nursery unit: When the green Low Battery indicator light flashes

replace batteries promptly. On the parents unit screen, the low

battery icon will flash and the nursery icon will appear.

Warnings

• This product is NOT a substitute for direct supervision of your

baby. Check your baby’s activities at regular intervals.

Monitoring of premature babies, or those considered to be at

risk, should be carried out only under the supervision of a

doctor or health professional.

• STRANGULATION HAZARD. Keep the adapter cord out of the

reach of children. Because of the serious strangulation risk to

infants and toddlers, parents and caregivers should never

place the nursery unit within 3 feet (1 metre) of a crib.

• Make sure you DON'T put the parents unit near wireless

devices and microwave ovens. This may disrupt the

transmission.

• ALWAYS place both units on a flat surface in an upright

position, away from baby’s reach.

• Make sure to plug the adapter to the socket outlet nearest to

the equipment and that is easily accessible.

• DO NOT touch the end of the adapter cord when plugged into

an electrical outlet.

• The Angelcare

Monitor uses public airwaves to transmit

signals. The parents unit may pick up signals or interference

from other nursery monitors in your area. Your monitor may

even be picked up by other households. To protect your privacy,

make sure both units are turned OFF when not in use.

• This product should be serviced by qualified personnel. There

are no user serviceable parts inside the monitor. Refer all

service questions to your distributor.

Care of you Angelcare

Monitor

RETAIN INSTRUCTIONS: Keep the user’s manual for future

reference.

1 2 3 4 5 6 7 8 9 10 11 ... 21 22

Comments to this Manuals

No comments

Angelcare AC420 Owner's Manual Page 6

Comments to this Manuals

Related products and manuals for Baby video monitors Angelcare AC420