4
E
N
4 EASY STEPS TO OPERATE YOUR ANGELCARE
®
MONITOR
NURSERY UNIT (TRANSMITTER)
• Insert 4 AAA regular batteries (not included) into nursery unit
(for battery backup in case of power failure).
• Connect AC adapter to nursery unit and plug adapter into an
electrical outlet in the baby’s room.
• After both units are properly installed (step1 and 2), turn
them ON and then adjust microphone sensitivity level (if
necessary).
Adapter socket
Microphone
sensitivity
dial
Charger adapter
socket
V
olume controls
(
up & down)
USING THE BATTERY MODE
• The monitor will revert to battery mode during a power
failure only if batteries are inserted in both units.
• When the nursery unit’s green light flashes, its batteries
need to be replaced. On the parents unit screen, the clear
battery icon flashes and the nursery unit icon appears. A
beep sound is also heard.
• Parents unit should be recharged when icon is clear (does
not flash) and a beep sound is heard. Note: Do not use
Alkaline batteries in the parents unit.
HOW TO USE YOUR MONITOR
• To be warned if your units are “out of range”, switch the In
Range Notification ON (optional).
• If reception is not clear, switch to another channel. (see
instructions for changing channel in the “ICON” section).
• To avoid feedback (whistling sound), keep both units at
least 3 meters apart (10 feet).
STEP 1 STEP 2
STEP 4
STEP 3
Power ON/OFF
Channel
selector
Low battery indicator
Channel selector
ON/ OFF night light
button
Power ON/OFF
In range ON/ OFF
PARENTS UNIT (RECEIVER)
• Insert 4 AAA NIMH rechargeable batteries (included) into
parents unit.
• Connect AC adapter to parents unit charger and plug adapter
into an electrical outlet. Let charge for 15 continuous hours
before using the monitor for the first time.
• After both units are properly installed (step1 and 2), turn
them ON and then adjust the volume control to the desired
level.
Comments to this Manuals